3M 7000048942 Masking Tape 18mm 60yd 6.3 Mil Tan

Product Description

The 3M 7000048942 is a tan paper masking tape designed for general-purpose bundling, holding, and surface protection tasks in professional trade and industrial environments. Built on a paper backing with a rubber-based pressure-sensitive adhesive, it measures 18 mm (approximately 0.71 inches) wide and runs 60 yards (180 feet) per roll at a thickness of 6.3 mil. The tape delivers 27 lb/in tensile strength, making it reliable under moderate mechanical stress. It is handled by painters, HVAC technicians, electricians, plumbers, and general contractors who need a dependable masking solution during finishing, coating, or assembly work.

This tape is suited for residential and commercial applications where a clean, controlled mask is required. Typical uses include paint masking, part bundling, cable management, and surface protection during fabrication or installation. The tape removes cleanly after baking at temperatures up to 250 degrees F (121 degrees C) for up to 30 minutes, making it appropriate for automotive and industrial powder-coat or bake operations. It is not recommended for use on EPDM rubber moldings or similar surfaces where removal may be difficult.

Key Features

• Rubber adhesive provides instant adhesion and pressure-sensitive bond on contact
• Easy-tear paper backing allows clean hand tearing without a dispenser
• Transfer-resistant adhesive leaves minimal residue on compatible surfaces
• Rated for use up to 250 degrees F (121 degrees C) for 30 minutes at bake temperature
• Meets standards A-A-883A, ASTM D-6123, and PPP-T-42C Type I
• 27 lb/in tensile strength for reliable performance under moderate load

Compatibility

Designed as a general-purpose paper masking tape suitable for most smooth and semi-smooth surfaces in painting, coating, bundling, and holding applications. Not recommended for EPDM rubber moldings or surfaces where difficult removal is a concern.

Installation Notes

Apply to clean, dry surfaces free of dust, oil, and moisture for best adhesion. Press firmly along the full length of the tape to ensure full contact and prevent bleed-through during painting or coating. Remove tape promptly after the bake or paint cycle is complete to avoid adhesive transfer. Painters and finishing technicians should follow applicable shop safety procedures when working in high-temperature bake environments.